UV system transformation is an important step in home decoration. whether the UV system transformation is good or not will also have a lot of influence on our future life. today's edition will introduce the process of UV system transformation and the knowledge of matters needing attention in UV system transformation.
Process of UV system transformation
Step 1: Bullet Line
The constructor and the owner determine the location point of the bullet line, the switch and the socket position, and use the ink bucket to pop up the needing slotted line.
Step 2: Slotting
Cutting machine along the elastic ink line on the wall and floor to cut out the need for concealed pipes and recessed boxes grooves.
Step 3: Clean up the dregs
Step 4: Installation of threading pipes
According to the direction of the groove, bend the line tube with a bending spring, and put both ends into the lock mother on the bottom box to install the bottom box. The lock mother should be installed in the proper position of the bottom box before loading the bottom box.
Step 5: Thread
The total cross-sectional area of the wire passing through the pipe should not exceed 60% of the cross-sectional area of the pipe.
Step 6: Connect various strong and weak wires
Step 7: Close the cell
Step 8: Benchmark photography with background
Matters needing attention in retrofitting UV system
The planning of UV system must consider the possibility, feasibility and usability before deciding. Nobody would like to have wires stretched all over the walls of their new home. UV system planning should also pay attention to its flexibility, sometimes not too "comprehensive". Summarized a relatively simple criterion: in the direction of electrical plugs relative to the assembly thinking in the future connected with a plugboard, the role is usually better than setting full wall sockets.